This Specification provides requirements for the classification of solid and composite carbon steel and low-alloy steel electrodes and fluxes for submerged arc welding and will be benefit welding professionals. Electrode classification is based on chemical composition of the electrode for solid electrodes, and chemical composition of the weld metal for composite electrodes. Fluxes may be classified using a multiple pass classification system or a two-run classification system, or both, under this specification. Multiple pass classification is based on the mechanical properties and the deposit composition of weld metal produced with the flux and an electrode classified herein. Two-run classification is based upon mechanical properties only. Additional requirements are included for sizes, marking, manufacturing, and packaging. The form and usability of the flux are also included. A guide is appended to the specification as a source of information concerning the classification system employed and the intended use of submerged arc fluxes and electrodes. This Specification makes use of both U.S. Customary Units and the International System of Units (SI). Since these are not equivalent, each system must be used independently of the other.Content:Front Matter Statement on the Use of American Welding Society Standards List of Tables List of Figures Table of Contents1. Scope2. Normative References3. Classification 4. Acceptance 5. Certification 6. Rounding-off Procedure7. Summary of Tests 8. Retest9. Weld Test Assemblies10. Chemical Analysis11. Radiographic Test12. Tension Test13. Impact Test14. Diffusible Hydrogen Test15. Method of Manufacture16. Electrode Requirements17. Flux RequirementsAnnexes AWS Filler Metal Specifications by Material and Welding Process